How to use an electric drill screwdriver？

　　How to use an electric drill screwdriver？

How to use an electric drill screwdriver:

The first thing to do is to choose the appropriate screw head. Choose the corresponding screw head according to the size and type of the screw.

When removing screws, first insert the electric drill plug into the socket and turn on the power switch.

Insert the screw head into the head of the electric drill driver, and then insert the screw head into the screw hole.

Turn the electric drill switch to control the speed of the electric drill to rotate the screws and nuts and loosen or tighten them. Be sure to use the correct direction of rotation, usually clockwise. If used in the opposite direction, the screw will be damaged or cannot be tightened.

After tightening or loosening the screw, take care to remove the screwdriver bit from the drill.

When using an electric drill screwdriver, you also need to pay attention to the following things:

Be sure to pay attention to safety to avoid accidental injuries during operation.

During use, pay attention to keeping the electric drill screwdriver and screw head vertical and rotating smoothly to avoid screw damage or improper maintenance due to improper use.

Before using an electric drill screwdriver, make sure that the power plug and socket are in good contact to avoid equipment damage or safety accidents due to power problems.

The above are the methods and precautions for using the electric drill screwdriver. I hope it will be helpful to you.